You Did It!

The title has also been created to make it look like a ribbon slider. Just make an insertion with a knife at the two ends of the title, just so long enough to fit the ribbon, and then thread your ribbon and tie/adhere behind a layer on the card front.

A selection of the products used in this project...

Watercolour Palette (White)

SO: Soft Grip Watercolour Brush - No 3

SO: Mini Foam Mounting Pads - White (3mm)

Mini Foam Mounting Pads - White (1mm)

SO: Chalk Eye Ink Pad - Olive Pastel

Organza Ribbon - White with Black Dots (Organdy)

SO: Marvy LePlume II Pen - Brown

SO: Marvy LePlume II Pen - Rosewood

SO: Marvy LePlume II Pen - Ochre

SO: Marvy LePlume II Pen - Olive Green

SO: Marvy LePlume II Pen - Black

Glossy Accents - Clear dimensional embelishment

Pinflair Odourless Decoupage Glue Gel Kit (Dries Clear)

Angle Tip Tweezers with Brad hole Puncher

SO: Magnolia EZ Mount - Graduation Tilda

SO: Magnolia EZ Mount - Congratulations (text)

SO: Embossing Powder - Detail Clear (Transparent)

VersaFine Ink Pad - Onyx Black

Hammer Card - 25 x A5 Sheets - White

SO: Craft Punch - Inverted Corner Rounder

SO: Art Flowers - Neutral

Snowy Jo Collection Gumdrop Brads - 5mm

SO: Bazzill Canvas - Raven (12x12) 25 sheets pack (309246)

SO: Bazzill Canvas - Gecko (12x12 cardstock) [D]

Junkitz - Essentials Paperz - Basic Skinny Stripe